Things To Note When Applying Thermal Insulation Film

Many car owners already know that they need to go to a regular car decoration store to apply a film, but most car owners may not know that on cloudy days, the air humidity is high and suspended solids in the air are significantly reduced, which can avoid impurities between the film and the glass that affect the appearance. the best time.
The film is most afraid of dust. Once sand or fine dust gets stuck between the film and the glass during the film application process, it will affect the quality and effect of the entire film. So be sure to choose a car service provider with a closed workshop. In addition, the front and rear windshields are the best test of the craftsmanship of the film, because they have large curvatures and large areas, which increases a lot of difficulty. So don’t be greedy for cheap, try to choose a large-scale and reputable car service provider to add a truly safe and effective barrier to your car.
The cleaning work of glass is the basic work for the quality of installation. Generally, there are three steps for cleaning glass: glass flaw detection, removal of rubber particles and gravel; glass dust cleaning (because water is required for dust removal and lubrication, pay attention to prevent water from leaking into the car's audio and electronic control systems, and must be cleaned three times); cleaning before applying the film . Be careful to protect the heating wire when cleaning the rear windshield.
When the store is required to affix the front and rear windshields, it is best not to cut them, but to affix them completely, otherwise the explosion-proof properties will be lost and the appearance will be affected.
After applying the film to the entire car, sit in the car and observe whether the color is uniform, whether there are bubbles, and whether there is too much grit. And looking out at various angles will not affect the line of sight.
Generally, car decoration shops have a box with glass and an infrared light source inside, and then stick a film on the glass surface to create a simulated sunlight-irradiated cabin environment. High-quality insulation film can obviously block heat radiation. You can tell by feeling it with your hands on the outside of the box.
A good membrane can generally be used normally for 5 to 6 years. Some brands of films have film warranty cards, remember to ask the merchant for them; for films without warranty cards, you must also keep various documents and invoices so that you can go to the merchant for "reasoning" if you have any problems.