Precautions For Car Film Operation

1. The water used when applying the film must be filtered or precipitated.
2. Film application generally requires a closed, dust-free environment.
3. Woolen clothes or clothes with cotton wool are not suitable for wearing when wearing stickers, because the cotton wool or wool on the clothes will be attracted to the paper by static electricity.
4. When the transparent paper is not disassembled, it must be washed or sprayed with water on the surface to prevent dust and sand.
5. When opening the paper, do not get too close to the object to avoid dust on the object being attracted by static electricity.
6. After washing the glass or when unpacking the paper, do not allow people outside the car to open the door to avoid bringing in a lot of dust or sand.
7. Avoid turning on the car air conditioner or fan when applying the film to prevent dust from items in the car from flying around quickly.
8. When removing the release paper, use a water sprayer to spray water mist on top. When we use the water sprayer, wipe the bottom first to avoid sand and small stones at the bottom falling on the membrane.
9. After removing the release paper, you must use two fingers to pinch the heat insulation film. The principle is to control the heat insulation film. Try to pinch as little as possible.
10. There is a fixed method for wiping to clean the glass. If you wipe casually or intermittently or do not know the end of the wiper, you will bring sand particles.
11. Old cars or triangular windows should be flushed with water, but the top should not be flushed to prevent dirt from sliding down with the water.
12. After removing the release paper, spray water to remove the glass sticker. During the process, the dashboard, steering wheel, rearview mirror, seat cover, glass frame or ceiling, stereo, etc. will sometimes get dirt.
13. After removing the release paper, spray water and try to stick it on the glass as accurately as possible. If you find that the position is much different after sticking it, if you move it again, it will be stained by objects around the glass, or rubber and sand in the mud tank.
14. Water can be driven from top to bottom, from right to left or from left to right, but a large amount of water cannot be driven from bottom to top to prevent the water from flowing downward and driving the sand down.
15. The film has been affixed to the glass and cannot be lifted again. The more times it is lifted, the more sand and dust particles will appear.
16. The attached dust should be scraped off, and any labels and dirt should be cleaned up in time, otherwise no matter how good the technique is, it will be of no use.
17. Wash the removed transparent paper before closing the glass and squeezing the water out with a water squeezer. This method will not scratch or break the insulation film.
18. There is a lot of invisible sand and dust hidden in the rubber in the mud groove around the old car. After the insulation film is closed, some of the glass has a large curvature, and there will be a sharp triangle shape with air and water. If the water is not driven out quickly at this time, , sand will continue to be pumped between the insulation film and the glass.
19. When the indoor mirror cannot be removed, cover the speaker with newspaper or tablecloth first, scrape the area around the stained area, and rinse it with water to avoid most sand particles. The scraping method should also be correct.
20. When cleaning the car windows, you should roll down the car windows first before cleaning to the top. After scraping the water and shaking the glass upward, do not wipe the top again.